Grade Percentage Calculator

Use this Grade Percentage Calculator to estimate volume for the Grade Percentage Calculator search intent. Use this elevation grade calculator to convert between rise, run, grade percentage, and slope angle. It is handy for grading, drainage, driveway planning, and any project where you need to understand slope quickly.

ft
ft
%
deg

Result

--

Quick Answer: Grade Percentage Calculator uses the same calculator logic as the canonical page. Grade = rise ÷ run × 100. A slope with 5 ft of rise over 100 ft of run has a 5% grade and an angle of about 2.86 degrees.

What This Grade Percentage Calculator Helps You Do

Use this elevation grade calculator to convert between rise, run, grade percentage, and slope angle. It is handy for grading, drainage, driveway planning, and any project where you need to understand slope quickly.

How to Grade Percentage Calculator

  1. Choose what you know - Decide whether you know rise and run, rise and grade, or another pair of values.
  2. Enter the values - Fill in the known measurements and use the correct units for your project site.
  3. Pick the solve-for mode - Choose grade, rise, run, or angle depending on the value you want to find.
  4. Use the slope result - Apply the result to drainage, grading, road, or ramp planning, then verify it against local requirements.

Grade Percentage Calculator Formula

Grade = rise ÷ run × 100
Symbol Definition Unit
Rise Vertical change in elevation ft
Run Horizontal distance ft
Grade Slope as a percentage %
Angle Slope angle deg

Working Examples for Grade Percentage Calculator

Grade Percentage Calculator - USA
  • Rise: 5 ft
  • Run: 100 ft

Result: Grade = 5 %. Angle = 2.86 deg.

A driveway with 5 feet of rise over 100 feet of run has a gentle 5% slope.

Grade Percentage Calculator - UK
  • Rise: 2 ft
  • Run: 40 ft

Result: Grade = 5 %. Angle = 2.86 deg.

The slope is the same ratio as the driveway example, so the grade is still 5%.

Grade Percentage Calculator - EU
  • Grade: 8 %
  • Run: 50 ft

Result: Rise = 4 ft.

An 8% grade over 50 feet creates about 4 feet of vertical change.

Grade Percentage Calculator - GCC
  • Rise: 3 ft
  • Run: 30 ft

Result: Grade = 10 %. Angle = 5.71 deg.

A shorter run with the same rise makes the slope noticeably steeper.

How to Interpret Your Results

Range Meaning Action
< 3% Very gentle slope Often suitable for drainage or mild grading.
3-8% Moderate slope Common in driveways, ramps, and exterior grading.
8-15% Steeper slope Check traction, drainage, and local accessibility rules.
> 15% Very steep slope Review whether the design needs retaining, terracing, or a different layout.

Frequently Asked Questions About Grade Percentage Calculator

Elevation grade is the slope of a surface expressed as a percentage. It shows how much vertical rise you get for a given horizontal run.

Use the angle mode. The calculator applies arctangent to the rise and run values and returns the slope angle in degrees.

Grade is easier to read on grading plans, drainage notes, and road layouts because it is a direct percentage.

Yes. Enter rise and grade, then switch the mode to run. The calculator will solve the horizontal distance for you.

It is mathematically exact for the numbers you enter, but the real site may vary because of rounding, compaction, or survey tolerances.

Yes. Grade percentage is often used to discuss ramps, sidewalks, and access slopes before a final code review.

Convert to feet first or use a consistent unit system for both rise and run before calculating.

Yes. As the angle increases, the grade percentage increases too because the slope becomes steeper.
Disclaimer: This calculator provides planning estimates only. Site grading, drainage, and access design should always be checked against local standards and survey data. This page also targets the Grade Percentage Calculator search intent.

Sources

Last reviewed: March 2026